Advanced Elements AF-4500s Guía de usuario descargar pdf (Pagina 118)

APPENDIX K: Vertical Power VP-X/PRO Interface

The 's' processor units are capable of interfacing to a Vertical Power VP-X/PRO electronic circuit

breaker unit. When enabled, the Vertical Power Status page can be accessed by pressing the

CHECK button on the EFIS screen (Pressing CHECK again brings up the Checklist).

The first few pieces of information are regarding

general electrical system status.

STATUS: Online/Offline

WIGWAG: Online/Offline

CURRENT: Total system current draw

PRI VOLTS: Voltage of primary bus

AUX VOLTS: Voltage of aux bus

The NAME, CURRENT , BREAKER, & STAT labels

reference whichever breaker is highlighted below.

Breakers are colored based on their fault status:

Green - OK

Gray - Not connected

Red - Tripped

VP-X Setup

Serial Port Connection - The VP-X/PRO can be wired to any of the 4 EFIS Serial Ports.

Set the SERIAL PORT FUNCTION to VP-X.

Line 36 of Instrument Calibration allows for programming the VP-X/PRO.

1. VP-X OFF/ON - Turns the VP-X interface ON or OFF.

Each circuit breaker can then be programmed by rotating the knob to change the character and

pressing the knob to advance characters.

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 128 129

Sin comentarios

Advanced Elements AF-4500s Guía de usuario Pagina 118